Accent RB (2012+) :: Idle Speed Around 900 RPMs When Put Car Into Neutral To Coast
Im curious if this is normal or not. When I'm driving and I put my car into neutral to coast, the idle speed is at around 900rpm. When I come to a stop, the idle will drop to around 650rpm. Is this a design feature? I wish the rpm would drop more to conserve on gas while I'm coasting!
View 7 RepliesAccent RB (2012+) :: Rattling Noise At Just Over 1500 RPMs
I've got a 2012 GLS manual with about 400 miles that now has a noise that concerns me. At just over 1500 rpms there is a rattling noise that sounds like its coming from the rear and underneath the vehicle. It sounds like metal vibrating. I think it could be the exhaust but I am not sure. It didn't do it on the test drive and it is fairly intermittent.
What it could be and if it might be normal? Should I take it in and get it checked out or would that be a waste of time?
Accent RB (2012+) :: Engine Vibration Starting At 3000 RPMs And Stopped Around 3100 RPMs
At the beginning December I put my brand new winter tires (general altimax arctics) on the factory steelies and put them on the car gearing up for the snow. Not to long after the install I notice that I was getting a very strong engine vibration starting at 3,000 rpms and it stopped around 3,100 rpms no matter what gear I was in. At first I though it maybe just the cold affecting the engine. Well...
Last week I put my summer rims and tires back on for the 1,600 mile trip to MO and back, and like magic, no more heavy vibrations. Smooth acceleration throughout the normal driving rpm range. I just changed the oil and tranny fluids Tuesday after we got back and with the warmer weather the car is running smooth as silk. Still an awesome car with awesome mileage and couldn't be happier.
Volvo - S40 :: Valves Tapping Noise When Reach About 2200 Rpms
I have an 06 volvo s40 with a 2.4l non turbo. When I reach about 2200 rpms I hear the valves tapping. When I put the car in park and rev the motor up the valves don't make any noise. Where to start.
View 6 RepliesAccent LC (2000-05) :: Idle Speed Lost And Engine Stops
Sometimes I loose the idle speed and the engine stops when I stop the car but it could be started again with full throttle it doesn't happen always it happens from time to time > I changed the MAP, IS actuator and TPS .The fuel pump and filter is new .In rare cases engine stops during driving. How about flash programming the ECU
View 1 RepliesAccent MC (2006-11) :: Rapid Tapping Noise On Startup Only
2009 Accent with a manual transmission
I am at about 65K miles so far. I changed my oil last night like I normally do. The car was on rhino ramps and as I started the car to back off the ramps, I noticed a very audible, "Tap tap tap" noise on start up, only. It goes away a second after I let off the key turn once the engine catches.
It did this when I backed it off the ramps and then when I shut the car off and waited a minute to check for it again on level ground and the same thing happened. Only two times and it has been quite as a mouse on start up since ever since. I want to say it is starter related as the noise sounds like a rapid tapping that slows and immediately stops as if the starting gear that engaged the flywheel is slowing to a stop once disengaged.
Sonata NF (2006-10) :: Tapping Noise That Increased And Decreased With Speed
While driving my 2006 Sonata yesterday I noticed a tapping noise that increased and decreased with speed. Not really loud, but audible. I looked and really didn't see anything. However, I looked earlier a little closer and noticed my left front wheel has a rubber looking belt, hose (unsure) laying across the inside part of wheel, closer to what I assume is caliper.
View 15 RepliesAccent RB (2012+) :: 2013 - Transmission Doesn't Work / Lost Fluid
Trnasmission problems? Plug came off lost fluid. transmission doesn't work.
View 2 RepliesAccent MC (2006-11) :: Idle Speed Will Increase To Around 1100 RPMs
I noticed on 5 different occasions so far this year that my idle speed will increase to around 1100 rpms when sitting at idle for more than a few min. Last summer it did it while running a/c, and today it did it with cold weather. The rpms are usually at 550, what happens is the pcm will decide to increase idle speed for no reason at all. Start driving it, and the next time at idle it will stop doing it, a couple times it went down to 550rpms, then went back up to 1100rpms. I recently changed the spark plugs, the air filter is clean, and runs good. I have a code scanner, no pending codes. I have 53k miles. I wonder what could cause this?
View 6 RepliesAccent LC (2000-05) :: Tapping Noise On Left Side Of Motor When Running
I've got a 2001 Accent 1.5 liter 5 speed. Car has 105,500 miles. Whenever the car is running, it makes an irritating tapping noise somewhere on the left side of the motor. I've been told that it sounds like the timing belt, but the car runs perfectly, doesn't miss. The tapping used to go away 30 seconds to a minute after starting it, but now it's constantly there and slightly louder. The noise goes with the rpms. When the rpms are higher, the tapping is faster. I've also noticed some loss of power. I recently added some octane booster to the fuel but noticed no difference. My uncle told me it may be a main bearing starting to go out but the tapping does not have a metallic tone of any.
View 3 RepliesIS F (2008-2014) :: 2011 - Clunk / Tapping Noise When Full Steering At Slow Speed
Just like the tittle says. My 2011 ISF with 56k miles on it is making a Clunking noise when pulling out of a parking spot or just anytime I fully steer to the left side and begin to move. If I try it in reverse it doesn't matter if I turn the steering wheel fully to left or right it makes the same noise as I begin to move at slow speed. It almost feels like something is pushing the front wheels out. During normal driving I don't feel anything at all, just as steady as solid the car can be.
Is there any common issues with ISF with premature wear of ball joints, cv joint, sway bar bushings or hub bearing?
Camry 2012+ :: 2014 - Chirping Noise When In Gear / Tapping On Gas
So i just had my torque converter recall done yesterday but before that happened i told the dealer that iv been experiencing a chirping like noise when in gear and when tapping on the gas. It's very quick and goes away once i ease off the pedal. Anyways they told me it could be the transmission. Mind you i had my car for a year. I bought the car brand spankin new and currently have 19,000 miles. All they said was oh hey come back if you still have that noise which i do. So im thinking they didn't even look into it because its pretty obvious the noise it makes. Im wondering what this could be?
View 9 RepliesAccent RB (2012+) :: Transmission Often Shifts At Very Low RPMs And CAI Makes Loud Burble
I installed the TurboKits CAI kit a few weeks ago. Installation went smoothly, and the latest kit has a modification to the box that fits our Accent's air snorkel. On cars with automatic transmissions, I had to cut out a notch from the bottom of the box to clear the transmission, but I doubt that this affects the air flow to the filter.
However, I have a big problem with the sound. The transmission often shifts at very low RPMs, and the CAI makes a very loud burble when this occurs. If I shift into a lower gear using the semi-manual mode, then the sound goes away. I realize that CAIs make a louder sound when you put your foot into it, but I find the sound a little over-the-top (especially considering that when the sound comes on, the engine is producing very little power at this part of the power band).
So, it's not really a problem with the CAI itself, more with the car's TCU. Unfortunately, it's too annoying for me, so I'll be reverting back to the original air intake system, and selling the TurboKits CAI.
Accent RB (2012+) :: Self Slowing Down At Low Speed When Not Accelerating
I just bought a new Accent. It seems to slow it's self down at low speed when not accelerating. In other words, it does'nt coast freely. Could this be a sticking brake caliper or a transaxle problem? Could it be related to the slippery road condtions feature on/off?
View 12 RepliesAccent RB (2012+) :: Disable Speed Sensing Autolock Feature?
Is it possible to disable the speed sensing autolock feature on the Accent?
View 2 RepliesAccent RB (2012+) :: Squeal Sound Coming From Tires When Driving On Normal Speed
A few weeks ago I heard my car was making this weird noise in the morning, when I go really slow, like when I'm parking in reverse or just getting out of my garage in neutral. It comes from the tires, I don't think the problem is in my breaks, because it doesn't make that sound when I'm breaking and I took my car to the dealer (forgot to mention the sound to them) but they said everything was fine, so my brakes should be fine...
Usually the car makes that squeal-sound in the morning. The sound goes away after I start driving on normal speed (40-45mph).
2012 Accent sedan, 5 speed manual.
Accent MC (2006-11) :: Rattling Noise At Around 5k RPMs
So i noticed recently, last month or two, a rattling noise coming from either rear of engine or in dash that only happens when at the higher rpms like 4-6k rpm. It goes away once rpms come down.
I am thinking just something in the dash is vibrating a little. No other issues as far as i can tell.
It is very slight, almost sounds like a plastic food wrapper getting crinkled in there....
Ford 6.0L Power Stroke Diesel :: Truck Lost Power And RPMs Dropped Only Glow Plug Light Came On
It's a 2004 6.0 excursion with about 190,000 miles. At 185,000 I pulled the motor and did new oem head gaskets, Arp head studs, bulletproof egr cooler and oil cooler system, bulletproof 48v ficm, strictly diesel regulated return, and I've been running gear heads srl tune before and after the truck was rebuilt.
Recently the truck has been acting up at random times. While running the gear head srl tune, the truck will lose power, the boost gauge on my edge insight will get stuck along with Icp psi, the water in fuel light and glow plug light will come on, and then after a few seconds it will clear itself and run fine. Last night I was on a two lane road and putting my foot into it and the truck did the same thing where it loses power, but this time the truck actually died on me while I was cruising at 60.
Same lights were on but this time the cruise control light fluttered while the truck was in the midst of dying. I tried restarting it and it took two sets of cranking before it fired and stayed running. On the way home I babied it and the truck lost power and the Rpms dropped and only the glow plug light came on. Got home and ran codes and I got camshaft and crankshaft position sensor codes and I tuned it back to stock, drove it around, and the truck ran fine, but while on a stock tune I am getting a egr valve code.
Camry :: Light Banging / Tapping Noise Coming From Intake Manifold Area
I have a 2003 Camry 4 cyl. around 60,000 miles on odometer and for around 3 months the engine seems to have gotten louder while at idle. At the back of the engine around the plastic intake manifold area the engine is making a light banging / tapping noise. It never made this noise before. The engine idles fine and the drives normally. I always keep an eye on the fluid levels and they are up to par. I'm not sure what is going on and if I should just keep an eye on it. I have provided a link below to a video of the noise. The noise can be heard best starting around 15 seconds into the video and fades away around 26 seconds into the video. [URL] ....
View 1 Replies