Accent MC (2006-11) :: Ignition Coil Getting Stuck?
Ignition coils on Hyundai Accent (2011) getting stuck in suction? Or looking for engine vacuum pathway explanation?
I previously (~6 months ago) replaced one ignition coil that had a misfire. I currently have a check engine light with "No Codes" on code reader. My engine is rough idling with very weak acceleration. This occurred when trying to accelerate up a hill. I was looking to inspect the coil resistance and noticed the replaced coil has a pretty strong suction holding it in.
Accent MC (2006-11) :: Engine Struggle And Stumble - Stuck Ignition Coil
My wife has an 09 Accent and a couple of days ago we were exiting the highway. As I stepped on the accelerator I noticed the engine struggle and stumble followed by the flashing MEL. I pulled into a parking lot and shut the car off and plugged the reader in to get the code but the computer already erased the code and the MEL light was extinguished and it ran fine the rest of the day. The following day my wife was driving it on the highway when the MEL light came back on but there was no associated engine roughness. I had her plug in the reader to get the code for me and it came up with P302 - misfire detected in the #2 cylinder. She didn't notice any engine roughness so I told her to drive to work but stay off the highway. She went out at lunch and the MEL light was off.
I did some research on here and the web and found the accent is known for going through ignition coils as well as a possible design flaw with the ignition wire harness that could cause it to rub and become frayed. I ordered the wire harness from our local Hyundai dealer and got an ignition coil from autozone. I also figured that I might as well get 4 spark plugs and replace them while I was at it. I got the plastic cover off and removed the 10mm bolt from the #2 ignition coil but it was wedged in there and would not budge. The coils from 1, 3, and 4 popped out with no issues. I ended up using almost a half a can of PB Blaster and 2 hours before the coil finally came out. The problem that I'm now looking at is some of the plastic from the coil remained stuck to the metal in the holder. Is there anything that I can use to clean out that metal cylinder?
After examining the spark plug from the #2 cylinder I could tell it was fouled and needed replacing but my concern is now that that new coil will get stuck in much the same manner. I'm pretty sure that the coils were WELL past due for replacement as I'm not sure when they, with the spark plugs, were replaced last. I'm pretty sure it was before my wife and I got together so that's more than the recommended 60k replacement intervals. I've ordered 3 more ignition coils to replace all of them and reset the 60k replacement interval. Since I replaced the one coil and 4 spark plugs the problem seems to have been corrected and the car is running great.
Ford Super Duty (1999-2016) :: How To Remove Terminals From Mirror Connectors
No special extraction tools are required, just a small jeweler screwdriver.
Push the screwdriver into the back of the connector, to push the Red terminal locking bar loose, then extract from the front.
Avalon 2005-12 :: 2006 - Burning Oil / Consecutive Ignition Coil Failures
I have a question regarding oil burning by the 2GR-FE V6. My avalon is a 2006 xls/navi, 160 000 km, very well maintained, only synthetic oil changes (AMSOL 5w-30, but switching to 10w-30 now that the oil burning began). All the recalls were done on it already, it was dealer maintained till 65k then I took over when we bought the car. The only other issue I had with it were the 3 consecutive ignition coil failures (by the way, you must replace those with oem toyota parts, I tried saving money on aftermarket and the results were discouraging).
View 2 RepliesFord F-150 (2004-2008) :: 2006 - Rough Idle After Replacing Ignition Coil
completely stock 2006 4.6, 230,000 miles, I purchased and can vouch for everything after 106,000.
Two separate issues...have had a slight ticking noise growing for about the last two years. Seems to get slightly worse near an oil change but that could be my imagination. It has finally gotten loud enough that my wife (who drives with the delicacy and observational skills of a Sherman tank driver) actually mentioned it to me the other day. It is directly related to engine speed whether the truck is in gear or not. I kind of think it might be a manifold gasket going out but am not sure. Am not very worried about it but...felt like I needed to mention it because of my bigger problem....
Truck has gotten very "cranky" on startup in the last week. Has a rough time finding an idle speed but typically sorts itself out after about 5-10 seconds. This afternoon it started idling rough at a stoplight. It got steadily worse and noticeable even at speed. Four stoplights and nine miles later it threw a code and coincidentally, I was in front of an Advance Auto. They read it and said the #3 cylinder was not firing. I bought an ignition coil, drove 15 miles home and changed it. From everywhere I looked online, this is the second cylinder from the firewall on the passenger side.
Had a little trouble getting it in and am not entirely sure it is fully seated in the slot, but I can't get it to go any further. Seems as tight as a couple of the others. I disconnected the battery to clear the codes, cranked it up and it seems to run "better", but still has a rough idle. Just test drove it about 12 miles and no check engine light but the idle has not cleared up. I think coil must be working fine because I have no issues at highway speed. Earlier, when I backed off the gas you would feel the miss very badly, but not as much when under a load.
Accent MC (2006-11) :: How To Remove Door Panels
How to remove the door panels? I tried to google it but I didn't have luck.
View 5 RepliesGolf IV R32 :: Remove Half A Coil Pack?
I was removing the coil packs on my car in preparation for the new ones coming in. The far right coil pack came out very easily and was about half as long as I expected. The other half of the coil pack was at the bottom of the spark plug well. I reported a misfire yesterday. As the mechanic would say "now there's your problem". removing the bottom half of a coil pack?
View 24 RepliesTouareg :: How To Remove Coil Packs To The Plugs
I've decided to jump on the DIY bandwagon a do my own 60K service. I've found the great write-ups on the oil changes, and even the spark plug removal; but need a detailed explanation or even pictures of how to remove the coil packs to the plugs; I don't want to break anything.
View 3 RepliesAccent MC (2006-11) :: 2007 - Ignition Key Will Not Turn To Start
Drove the car yesterday all was fine. Came home and shut it off. Went to start it about an hour later and the ignition key will not turn. Tried a second key and still no luck. Disconnected the battery and waited for about 10 mins. Reconnected battery still no luck. Wiggled steering wheel and shifter (automatic) still no luck.
View 16 RepliesAccent MC (2006-11) :: Parking Lights Staying On When Turn Ignition Key Off
I have a 2006 hyundai accent when I turn the ignition key off the parking lights stay on but its doesn't happen all the time.
View 1 RepliesGolf IV / Jetta IV :: Coil Pack Sparking When Try And Remove Hex Bolt
I'm in the middle of replacing my VC gasket and while I was removing one of the hex bolts that holds it in it started sparking like crazy and turned the tip of the hex wrench glowing red. It didn't do this for the first bolt I took out. I also forgot to disconnect the battery before I started, could that have had anything to do with it?
View 6 RepliesAccent MC (2006-11) :: When Turned The Ignition On It Sounded Like Starting But Didn't Catch
I have a 2008 Accent, automatic, with 167,000 mostly city kilometers on it. 3 times, yesterday and today, when I turned the ignition on it sounded like it was going to start but didn't catch. When I tried again the second time it started. At first, I thought I just didn't turn the key to the right long enough but with it happening 3 times, I am not so sure.
I called my mechanic and he thought it might be the fuel pump. He suggested I turn it to the right then back 2 times, then start it the third time. I have spent a lot on it lately, new tires in April, transmission fluid, also had to replace the tie rod on one front wheel and bearings on the other. If it is the fuel pump, what happens if I don't replace it soon?
Ford Super Duty (1999-2016) :: 2006 F250 - Trailer Wire Harness Bracket - Connectors Hanging Loose
I have a 2006 F250 and my 7pin and 4 pin connectors are just hanging loose. I'm not sure what happened to the factory bracket. What is the part number for this bracket? Also, where does it mount to? I looked under the truck and couldnt tell where the factory one mounts.
View 4 RepliesCamry :: 2002 / 2.4L Ignition Coil Failure
I have a 2002 Camry 2.4L, ECM 89666-06220, ignition coil 90919-02243. One of the coils has gone out. I got a misfire code on P303. I then moved the cylinder 3 coil to cylinder 4, cleared the code and restarted the car. The new code was P304, bad coil. I found a set of low mileage used coils, 90080-19023. The dealer says this number was one of the three options for 2002. But the pin-to-pin ohm values don't match.
The 90080-19023 pin ohms, 1-2= 348, 1-3=667, 1-4= 490, 2-3= 1100, 2-4= 912, 3-4= open. The 90919-02243 pin ohms, 1-2= 390, 1-3= 673, 1-4=940, 2-3= 1154, 2-4=1403, 3-4= open. How to successfully do this substitution and not burned up ECM ?
Volvo :: No Spark Coming From The Ignition Coil
I have a 1991 Volvo 940 SE with turbo and 162,000 miles
The problem is there is no spark coming from the ignition coil. There is power going to the ignition coil but no spark. The car turns over but doesn't start.
I have replaced the crankshaft sensor and the Ignition Module. The wire that goes from the ignition module to the Ignition Coil has been replaced with a new wire that goes directly from the module to the coil .
Also the coil has been checked and its operating within parameters.
Honda - Fit :: 2007 - Ignition Coil Replacement
Understanding all the needed parts when replacing ignition coils on a honda fit 2007. My understanding is it is best to replace all 4 (are there 4 total?) as well as the spark plugs - also 4?What other parts are needed, does this car require spark plug wires?
Basically, Would this be a good time to replace air filters as well? Car has 116K miles.
Civic - Honda :: 2003 - Bad Ignition Coil
Found out today that my third ignition coil is bad, it's a Honda civic 03' my question is, do I have to buy a new ignition coil. I had a clerk tell me I could switch the coils and it would run fine? Is this right? could I just switch the ignition coil with another ignition coil? This doesn't sound right. Well If I do buy new one which would be the third ignition coil? is it counted from left to right or right to left? Are there any telltale signs of a bad ignition coil on sight?
View 16 RepliesHonda - Accord :: 2000 - Bad Ignition Coil
2000 Honda Accord. I've been told I have a bad ignition coil. Do I need to replace all six or can I just replace the one?
View 19 RepliesLexus RX 2004-09 :: 2007 RX 350 2WD - Ignition Coil F Replacement
I have a 2007 RX 350 2WD. Recently, the check engine light is on, as well we two other lights are on as well: VSC, TRAC OFF.
I went to Lexus and was told that the error code is P0356. I was told that the ignition coil F is problematic and need replaced. I was quoted 1 and 1/2 hours two 2 hours work and need $412 for the repair. Well, I went to auto zone and was told that No 2, 4, 6 ignition coils were on outside so that it would only take about 5 minutes to replace the problematic one with a new one.
I did the replacement indeed by myself after buying a new ignition coil. Initially it was fine and the light went off after a little while. However, after about 10 days, those three lights went back again. I check the ignition coil, it seems fine and I was told that it is very unlikely for a new ignition coil to go bad this quickly.
I was told that I may need to check my spark plug as well. BTW, when I start the car, the car is a little bit shaky.