Accent LC (2000-05) :: Engine Stops Accelerating At High RPM With AC On
I need diagnosing a problem on my 2002 Hyundai Accent LC. When I accelerate with the aircon on the engine stops accelerating at high RPM and when I accelerate from a stand still the engine hesitates and jerks! I don't understand what the problem may be coz it works perfectly after a cold start but after it warms it starts doing that.
View 3 RepliesAccent LC (2000-05) :: 2003 - Auto Downshifting When Let Off The Gas On Highway
Just bought this car and when I am on the highway I let off the gas and it automatically downshifts. no engine light or anything. and when I press the gas again it returns to the proper gear.
View 3 RepliesAccent RB (2012+) :: Rough Idle / Stall At Stops And Tough Time Accelerating
Noticed this to be a problem with our older 2011 Accent, now with the 2012 Accent.
The car has a rough idle usually in mornings, it seems like it is going to stall at stops, it also has a tough time accelerating.
The computer scan does not show there is anything wrong until the problem becomes worse.
This is what I have discovered through the 2011 Accent. Car will stall at stops. Very inconvenient in rush hour traffic. Until they replace the Crankshaft Point Censor, the problem would not go away.
I would insist on looking at this rather than replacing sparkplugs or having any other service performed if one is experiencing these same symptoms. The good thing is it is under warranty.
Ford F-150 (2004-2008) :: Transmission In Drive - Truck Almost Stops Accelerating At About 2000 RPMs
Well I am not sure if i have trans problem or not. If I put the trans in drive and go through the gears when the RPM's get to about 2000 the truck almost stops accelerating, until you give it much more gas, this happens in every gear. but If you push the button to take it out of overdrive and drive like that it doesn't do it.
View 1 RepliesAccent LC (2000-05) :: Warm Engine Stops And Needs To Be Run Again After 5 - 15 Minutes
My friend's Accent LC 1.3L won't start from time to time. This never happens on cold start, this is always the situation after warm engine stops and needs to be run again after 5-15 minutes. When you try to turn on the car then, starter is rolling the engine but nothing happens (Yellow key light on dashboard is on, so there is no problem with a key code). Then he wait for a few minutes and car starts like it nothing happens. I suspect the crankshaft sensor.
View 2 RepliesAccent LC (2000-05) :: Power Steering Pulley Stops Spinning
I have a 2002 Accent 1.6L and when I turn the wheels all the way too the right or all the way to the left the pulley stops spinning. Could this be that the pump is going bad or something else?
View 2 RepliesAccent LC (2000-05) :: Idle Speed Lost And Engine Stops
Sometimes I loose the idle speed and the engine stops when I stop the car but it could be started again with full throttle it doesn't happen always it happens from time to time > I changed the MAP, IS actuator and TPS .The fuel pump and filter is new .In rare cases engine stops during driving. How about flash programming the ECU
View 1 RepliesFord F-150 - 1997-2003 :: Engine Revs Up And Stops Accelerating Usually When Shifting Around 30 - 35
2001 F150 5.4 v8 ... In the past few months my truck has been a bit strange, but in the past few weeks it's gotten to the point I'm nervous to drive it. Usually when shifting around 30-35, the engine revs up and stops accelerating and I have to take my foot off the pedal to make it return to normal. It doesn't do this after I do that, but the past time I tried to drive I couldn't get above 35 and the rpm was in the upper 2000s going at a constant 35. When I stop for any reason such as making a turn, when it shifts it lurches forward and I hear a loud clunk.
Naturally, I've checked all the fluids and fuses and they're all fine. The mechanic I regularly visit insists that nothing is wrong with it.
Accent LC (2000-05) :: Random Increase In Highway RPM
So yesterday driving home from work, I was cruising at 70mph, which puts my RPM's just at 3000. Then I notice an increase in RPM by about 200-300, and I didn't even move my foot or give it more gas or anything, almost like it cam eout of overdrive. It did this about 5 times. I've got about 60k on a used tranny, so I don't think that could be the issue. Not sure what it could be...
View 8 RepliesAccent LC (2000-05) :: Vibration At High Speeds On The Highway
Getting some vibration at high speeds on the highway, and when I changed my wheels, I noted that there seems to be some free play in the ball joint on the end. Is this normal? Can I replace just the end of the tie rod?
View 3 RepliesAccent LC (2000-05) :: Engine Quit When Driving Down The Highway
Driving down the highway today, my car just all of a sudden quit. I had it towed home, and checked the spark and fuel pump. It turns over fine, there's plenty of spark, and the fuel pump works great, but I don't think fuel is getting all the way to the engine. Could the fuel line be blocked or something? Maybe the injectors?
View 3 RepliesAccent LC (2000-05) :: Clicking While Accelerating And Slowing Down
My 2005 Accent began making an odd clicking sound about two years ago when I would decrease my speed, not using the brakes. It wasn't loud, just annoying. It went on for some time until my car went into the shop to have the alternator replaced. I explained the noise to the mechanic and they checked it out. They explained they added some type of cleaning fluid somewhere under the hood, and the sound was gone. I was thrilled.
Last year, the sound returned again. Annoyed, I began saving to bring it in to the shop again. In Feb 2013, I had my timing belt and water pump replaced because my mileage of course called for it. The mechanic said he could not hear the clicking sound I was reporting (I really didn't see how.)
Two months later in April, my car decided to die on me and after 5 months I just recently got it up and running again. My differential and transmission were both completely rebuilt. Also, my CV axles have both been replaced. Now that I have my car back, the clicking sound is louder than before and also now happens when I accelerate as well. The faster I go, the faster the clicking gets until it eventually stops. When I slow down, the clicking starts again until I hit my brakes.
I want to take my car and get this noise silenced once and for all since they didn't hear it when my transmission was done last month. What fluid may have been added to what part 2 years ago when this was handled initially?
Accent LC (2000-05) :: Steering Wheel Shakes Quite A Bit At Highway Speeds 70 MPH
My accent just crossed 180K mark. From last year the steering wheel shakes quite a bit at highway speeds ,say 70MPH. It's especially bad when I accelerates . Took the car to a shop, they told me two things, the CV axle of passenger side needs replacement, and the wheel hub bearings are bad(both front wheels). They quoted me $200 for replacing the cv axle, and $400 for replacing both front wheel bearings. Since I don't even think the car worth $600 right now(given high mileage), I told them I'll just do the axle(I know how to do it myself but don't have the time, plus it won't be that much cheaper DIY anyway). They said fine, but if you don't replace the bearings you may have the wheel fly off one day and that's dangerous.
They replaced the axle, and the car drives a lot better now. There's still a little bit of shaking at high speed but 75% of that shake has gone away. My question is, does the worn out bearing causes car to tremble at high speed? I heard other people told me there should be a grinding or loud hawling sound if the bearings are bad, but I don't hear that. I searched the internet and some people say, to determine if the hub bearings are bad, just drive it for 10 minutes then feel the hub. If it's barely warm, the bearings are good. If it's warm to hot, then the bearings are bad. I felt it and it's warm, but not too hot to touch. I tried the rear wheels and those are barely warm indeed.
So from this method it seems the front wheel hub bearings are indeed bad. I wonder how long I can keep driving this without endanger myself. $400 is not cheap for this car and I don't have a machine to press in the bearings myself. I can disassemble the rotor and hub that's not a big deal, but I don't know how to get the old bearing out and the new bearing in. Is there a machine shop that just do the pressing? Or, is there any shop selling the hub assembly with bearing already in place? this way I just remove the old hub assembly and replace it with the new assembly, a lot easier. I searched the internet but can only find pre-assembled hub w/ bearing for the rear wheel of this car. I need the front ones.
Accent LC (2000-05) :: Running Rough When Cold But Only When Accelerating
My 2000 Accent 1.3 has developed a problem recently: starts fine and revs freely and smoothly when parked. When I pull away it will get very rough like it's firing on only 2 cylinders or so, at certain points during the rev range rather than continuously. Very juddery.
After a minute or so, before the engine temp is even up to normal operating temp (according to the dial) it runs perfectly. When I start it up later the same day it's fine. It only happens the first time in a day that I use it. The more days I go without driving it the worse it is.
In the last couple of years I've changed spark plugs (always in good condition when I replace them), HT leads, coil pack, a lamda sensor (the first after the exhaust downpipe) and a fuel pump and filter.
Accent LC (2000-05) :: Whining Noise In Second Gear If Accelerating At A Normal Pace
I have a 2005 accent with a 5 speed, it has about 80,000km on it.... mainly city driving. Lately, once the car is up to temp. as I pull away from a stop the car makes a loud noise and I really need to feather the clutch out. The noise continues after shifting into second gear ,but no other gears. Thus happens under normal acceleration. If I pull away extremely slow the noise isn't there. If I don't feather the clutch the car lurches like I'm just 'dumping' the clutch and driving like someone who is just learning to drive. Sometimes there is also a whining noise in second gear if I am accelerating at a normal pace. Where I should start looking? I am assuming it's the clutch due to the fact that it happens after everything warms up.
View 3 RepliesGolf VI R :: Stops Accelerating At 135 MPH - No Turbo
I got my R flashed about a month ago and decided to do a little run 2 days ago at my local track (BYW I am APR stage 1+) Because I thought the software removed the speed limiter of 125 MPH, I was suprised when car got to 135 and completely stopped accelerating. When I slowed down, it was like the car had no turbo. I would press on the gas and it would barely move.
Idk if it was the turbo or the software. When I stopped I turned off the car and turned it right back on and BOOM, it was back to normal. So yesterday, the same thing happened at 110 MPH and I restarted it and everything was back to normal but now the Engine Malfunction Light is on but everything is working fine.
Metro :: Engine Stops Then Takes Off Again When Accelerating Over 70
I have a 97 metro runs good but when accelerating over 70 when you let off engine shuts down for a few seconds then takes off again. Replaced fuel pump and filter to no avail. It must be a fuel problem no misfire.
View 11 RepliesFord F-150 - 1997-2003 :: 2000 - Bouncing / Shuddering On Highway - Cylinder 5 Misfire
I have a 2000 f150 5.4 liter engine. I traveled about a month ago and while on the highway it started "bouncing/shuttering" really bad. I pulled off and while still in drive but completely stopped it was still bouncing but when in park it stopped. I took in into the Ford dealership and they said that cylinder 5 was misfiring and it was losing pressure fast. Then it stopped acting up completely and they couldn't find anything wrong with it.
Well about a week ago it started bouncing again on city roads (no highway). The check engine light came on and Orielys said it was a cylinder 5 misfire. Also, under the oil cap and in the tube where you would put the oil in has a yellow thick substance on it. I know that it is water in the oil. Also, there is a black "gunk" not far from where you would put the oil in. Could these problems be connected?
Jetta - Volkswagen :: AC Air Stops Blowing Into Cabin During Highway Driving
Have a 2007 jetta. A/C works well. However when highway driving the air stops blowing into cabin as if someone had shut all vents. When slow down, problem goes away. Took it to dealer and they have no clue.
View 7 Replies